Ohje
xcos malli testausta varten EkaKertaluvunMalli.xcos
Tuo ensin xcos malli työtilaan funktiolla importXcosDiagram
-->importXcosDiagram>importXcosDiagram("/home/jes/Documents/scilab/EkaKertaluvunMalli.xcos")
Putsaa työtilasta vanhat simulaatiot
-->clear post_xcos_simulate;
-->pre_xcos_simulate(scs_m, 4)
Tee alla kuvattu funktio
| Code Block |
|---|
function continueSimulation=pre_xcos_simulate(scs_m, needcompile)
// Retrieve all objects
objs = scs_m.objs;
clrBlock = [];
//Looking for CLR block
for i=1:size(objs)
if objs(i).gui == "CLR" then
clrBlock = objs(i);
break;
end
end
// Check if we found some CLR
if isempty(clrBlock) then
disp("No CLR block found.")
return
end
// Retrieve exprs
exprs = clrBlock.graphics.exprs;
s = poly(0,'s');
num = eval(exprs(1));
den = eval(exprs(2));
h = syslin('c', num/den);
// Open new figure then plot Bode
scf(max(winsid())+1);
bode(h, 0.01, 100);
// Stop after bode plot. We do not want any simulation.
continueSimulation = %f;
endfunction
|
...